Skip to main content

Guide:Deploy TideCloak with Docker

This guide will help you get started with deploying TideCloak using Docker. Follow the steps below to set up and run TideCloak in a Docker container.

Prerequisites​

Before you begin, ensure that you have:

  • Docker: Installed and running on your machine.
  • Basic knowledge of Docker and command-line interface (CLI).
  • An understanding of TideCloak and its use in identity and access management.

Installing Docker​

If you haven't installed Docker yet, follow the steps below for your operating system.

Installing Docker on Windows​

  1. Download Docker Desktop:

    • Visit the official Docker website:Docker
    • Download the Docker Desktop installer for Windows.

  2. Install Docker Desktop:

    • Double-click the downloaded installer to begin the installation.
    • Follow the installation prompts. During the installation, you can choose to enable WSL 2 (Windows Subsystem for Linux), which is recommended for better performance.
    • Once the installation is complete, launch Docker Desktop.

  3. Verify Docker Installation:

    • Open Command Prompt or PowerShell and run the following command to verify that Docker is installed correctly:
    docker --version
    • You should see the Docker version information displayed.

  4. Start Docker Desktop:

    • Docker Desktop should start automatically after installation. If not, you can start it from the Start menu.
    • Ensure that Docker is running by checking the Docker icon in the system tray.

Installing Docker on Linux​

  1. Update Your Package List:

    • Open your terminal and run the following command to update your package list:
    sudo apt-get update

  2. Install Docker:

    • Install Docker by running the following commands:
    sudo apt install docker.io
    • You may be prompted to confirm the installation. Press Y to proceed.

  3. Start Docker Service:

    • Ensure Docker starts automatically with the following command:
    sudo systemctl start docker
    • To enable Docker to start on boot, run:
    sudo systemctl enable docker

  4. Verify Docker Installation:

    • Run the following command to verify Docker is installed correctly:
    docker --version
    • You should see the Docker version information displayed.